PS Eliminator PAIR system eliminator module
Get rid of the annoying FI light coming on when removing or disconnecting the PAIR system from your motorcycle. Get the job done right!
Proper solution
Eliminates the FI light coming on when removing the PAIR system from the bike. This is a must have piece of kit for racers!
Plug ‘n Go
No cutting and splicing needed. Just connect it and you’re ready to go. It can’t get any easier than this.
Tough design
The product comes in a rugged, 100% weatherproof housing and with a 2-year replacement warranty.
local_shipping Vi sender med
Fraktpris fra kr. 99.-
NB! Hvis du ikke er helt sikker på om du har valgt riktig produkt, så er det lurt å gi beskjed om dette i meldingsfeltet på ordren.
Skriv inn hvilket kjøretøy du skal ha produktet til. Vi kan da sjekke om du har valgt riktig uten å måtte kontakte deg.
Husk å bruke folkeregistrert adresse.
Introduction
The PAIR system on modern sport and street bikes injects fresh air to the exhaust. Doing so, it minimizes the amount of unburnt fuel getting to the atmosphere. This is why the popping occurs on heavy deceleration, as the unburnt fuel is combusting in the end can.
Whether you just simply want to get rid of the popping, or opting for a dyno tune, the PAIR system is in your way. However, disconnecting the PAIR valve from the bike’s main harness will instantly result in the FI light coming on (which could mask some serious bike/engine related faults).
The PS Eliminator will do the trick in a blink of an eye – just plug it in to the PAIR valve’s connector and you’re all set!
(Race use only!)
